Challenger Tractor Fault Codes List: 10.X.33 to 1761
Page 2 of 25 of the full Challenger Tractor fault code list (2,434 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.
Challenger Tractor codes 10.X.33 to 1761
- 10.X.33X450 - Motor for Right-Hand Heating Shutter
- 11Measured Current < 13 mA of Specified Current
- 110Short Circuit on +12V Coming From Analog Lever
- 1132Inlet Temperature Sensor on the Manifold
- 1136ECU Temperature Too High > 120xC
- 1188Wastegate Actuator
- 11ERRX123 - High/Low Speed Range (Hare/Tortoise) Shift Switch is Faulty
- 12Measured Current < 13 mA of Specified Current
- 123Faulty Reed Analog Lever Switches (ILS)
- 1239Rail Pressure Sensor
- 1240Rail Pressure Sensor
- 12ERRX68 - Clutch Pedal Sensor: The Pedal is Not Pressed
- 13Detected by Electrohydraulic Spool Valves
- 132Air Flow Sensor
- 1321Starter Relay
- 1378Engine Protection
- 1381Pressure Sensor of the Fuel Suction Pump
- 13ERRThe Values Stored in the Transmission Controller are Not Logical
- 13.X.01X38 - Proportional Solenoid Valve for Hydraulic Trailer Braking
- 13.X.02X38 - Proportional Solenoid Valve for Hydraulic Trailer Braking
- 13.X.03X38 - Proportional Solenoid Valve for Hydraulic Trailer Braking
- 13.X.04X337 - Pneumatic Park Brake Solenoid Valve
- 13.X.05X337 - Pneumatic Park Brake Solenoid Valve
- 13.X.06X337 - Pneumatic Park Brake Solenoid Valve
- 13.X.07X339 - Progressivity Solenoid Valve for Pneumatic Trailer Braking
- 13.X.08X339 - Progressivity Solenoid Valve for Pneumatic Trailer Braking
- 13.X.09X339 - Progressivity Solenoid Valve for Pneumatic Trailer Braking
- 13.X.0BX39 - Safety Solenoid Valve for Hydraulic Trailer Braking
- 13.X.0CX39 - Safety Solenoid Valve for Hydraulic Trailer Braking
- 13.X.0EX39 - Safety Solenoid Valve for Hydraulic Trailer Braking
- 13.X.15X37 - Park Lock Pressure Reversing Solenoid Valve
- 13.X.16X37 - Park Lock Pressure Reversing Solenoid Valve
- 13.X.17X37 - Park Lock Pressure Reversing Solenoid Valve
- 13.X.18X67 - Right-Hand Brake Pedal Sensor
- 13.X.19(X135) - Braking Pressure Sensor
- 13.X.1AX35 - ParkLock Hydraulic Pressure Sensor
- 13.X.2D(X135) - Braking Pressure Sensor
- 13.X.2EX35 - Park Lock Hydraulic Pressure Sensor
- 13.X.2FX21 - Park Lock Brake Pressure Sensor (ML260)
- 13.X.30X21 - Park Lock Brake Pressure Sensor (ML260)
- 13.X.38X891 - Steering Pressure Sensor/Standby Pump
- 13.X.41X671 - Parklock Solenoid Valve in Road Mode
- 13.X.42X671 - Parklock Solenoid Valve in Road Mode
- 13.X.43X672 - Parklock solenoid Valve When Stationary
- 13.X.44X672 - Parklock solenoid Valve When Stationary
- 13.X.45X672 - Parklock solenoid Valve When Stationary
- 13.X.46X671 - ParkLock Solenoid Valve in Road Mode
- 13.X.47X674 - ParkLock Status Switch
- 13.X.48X674 - ParkLock Status Switch
- 13.X.49X674 - ParkLock Status Switch
- 13.X.4AX72 - ParkLock Switch on Power Direction Lever
- 14Error at Recirculation Shutter Motor Supply
- 1485EEM4 Controller
- 14ERRThe Pressure of the Transmission is Too High at the Start of Calibration (Greater Than 100 Bar)
- 14.X.01X135 - Braking Pressure Sensor
- 14.X.02X135 - Braking Pressure Sensor
- 14.X.03X135 - Braking Pressure Sensor
- 14.X.04X135 - Braking Pressure Sensor
- 14.X.05X135 - Braking Pressure Sensor
- 14.X.06X135 - Braking Pressure Sensor
- 14.X.07X135 - Braking Pressure Sensor
- 14.X.08X135 - Braking Pressure Sensor
- 14.X.09X135 - Braking Pressure Sensor
- 14.X.0BX135 - Braking Pressure Sensor
- 15Potentiometer Recirculation Actuator (No. 1 & 2) Reference Error
- 15.2.77X261 - Front Right-Hand Unit for Suspended Cab
- 15.2.78X261 - Front Right-Hand Unit for Suspended Cab
- 15.2.79X261 - Front Right-Hand Unit for Suspended Cab
- 15.2.7AX262 - Front Left-Hand Unit for Suspended Cab
- 15.2.7BX262 - Front Left-Hand Unit for Suspended Cab
- 15.2.7CX262 - Front Left-Hand Unit for Suspended Cab
- 15.2.7DX49 - Suspended Cab Rear Lowering Solenoid Valve
- 15.2.7EX50 - Suspended Cab Front Lowering Solenoid Valve
- 15.2.7FX54 - Suspended Cab Lifting Solenoid Valve
- 15.2.80X49 - Suspended Cab Rear Lowering Solenoid Valve
- 15.2.81X49 - Suspended Cab Rear Lowering Solenoid Valve
- 15.2.82X49 - Suspended Cab Rear Lowering Solenoid Valve
- 15.2.83X48 - Rear Left-Hand Unit for Suspended Cab
- 15.2.84X48 - Rear Left-Hand Unit for Suspended Cab
- 15.2.85X48 - Rear Left-Hand Unit for Suspended Cab
- 15.2.86X47 - Rear Right-Hand Unit for Suspended Cab
- 15.2.87X47 - Rear Right-Hand Unit for Suspended Cab
- 15.2.88X47 - Rear Right-Hand Unit for Suspended Cab
- 15.2.8CX48 - Rear Left-Hand Unit for Suspended Cab
- 15.2.8DX262 - Front Left-Hand Unit for Suspended Cab
- 15.2.8EX47 - Rear Right-Hand Unit for Suspended Cab
- 15.2.8FX261 - Front Right-Hand Unit for Suspended Cab
- 15.2.90Upper Stop Calibration Error
- 15.2.91Lower Stop Calibration Error
- 15.2.92No Calibration Value Recorded
- 157Rail Pressure Sensor
- 15ERRThe Pressure of the Transmission is Too High at the Start of Calibration (Greater Than 200 Bar)
- 16Input Error From Selected Temperature Potentiometer
- 1639"Vistronic" Fan
- 168Battery Voltage Low (<7.8V)
- 16ERRX9 - Transmission Oil High Pressure Sensor 1 is Faulty
- 17Detected by Electrohydraulic Spool Valves
- 171Ambient Temperature Sensor
- 174Fuel Temperature Sensor
- 1761DEF Tank Gauge
Other Challenger machine types
Fault code lists by brand
- CAT8,286 codes
- Volvo6,508 codes
- New Holland Tractor3,475 codes
- FPT3,033 codes
- Case IH2,992 codes
- Bobcat2,653 codes
- New Holland Combine2,274 codes
- John Deere Tractors1,884 codes
- Case Wheel Loader1,859 codes
- John Deere Engines1,853 codes
- Cummins1,847 codes
- Volvo Wheel Loader1,726 codes
- Deutz1,684 codes
- Perkins1,523 codes
Safety-critical: confirm before use
Safety first: park on level ground, stop the engine, and secure the machine before any inspection. Thresholds, component locations, wire numbers, fuse locations, and reset procedures can vary by model, configuration, and serial number. Confirm them in the service documentation for your exact machine.