Case IH Fault Codes List: 5035 to 7216
Page 22 of 30 of the full Case IH fault code list (2,992 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.
Case IH codes 5035 to 7216
- 5035Rear PTO Fender Switch - Input Short To 12V+
- 5037Rear PTO Cab Normally Open Switch - Stuck Closed
- 5042PTO Management Switch - Stuck Closed
- 5043Rear PTO Fender Switch Stuck On Error
- 5044PTO Speed Sensor Short Circuit To Ground
- 5045Ground Speed PTO Switch Open Or Short To Ground
- 5046Ground Speed PTO Switch Short To 12V
- 5047Ground Speed PTO Configuration Error
- 5070PTO Clutch Solenoid 12 Volt Circuit Error
- 5080PTO Clutch Solenoid Excessive Voltage
- 5098Rear Power Take-Off (PTO) Fender Switches - Option Not Enabled
- 5099Rear PTO Auto PTO Not Enabled
- 515ADEF Supply Module Pump Motor Open Load
- 5171After Run Relay High Side Driver Circuit Open Failure
- 51B5Fuel Filter Heater Actuator Has an Open Load Error
- 5255Fuel Metering Unit Has an Open Load Error
- 5262Uncommand Movement Of Synchronizer F4/R2 To Neutral
- 5316Open Load Error of Injector in Cylinder 1
- 5416Open Load Error of Injector in Cylinder 3
- 5516Open Load Error of Injector in Cylinder 3
- 5533Fan Clutch Solenoid Open Load Failure
- 5614Intake Air Heater Actuator Has an Open Load Error
- 5616Open Load Error of Injector in Cylinder 2
- 569ADEF Tank Heater Actuator Open Load Failure
- 5716Open Load Error of Injector in Cylinder 2
- 5816Open Load Error of Injector in Cylinder 4
- 5922Starter Relay Low Side Driver Circuit Open Failure
- 5971After Run Relay Low Side Driver Circuit Open or Short to Ground Failure
- 5B61Auxiliary Power Relay Low Side Driver Circuit Open Failure
- 5E5ADEF Reverting Valve Driver Circuit Open Failure
- 6Airflow Sensor Short To Ground
- 6001MFD (CCH) Or Front Diff Lock (4WD) Solenoid Failed. Possible Failure Modes: 1. Solenoid Coil Failed 2. Damaged Wiring 3. Loose Connector Or Bent Pin 4. TCU Internal Failure.
- 6002Rear Diff Lock Solenoid Failed. Possible Failure Modes: 1. Diff Lock Solenoid Coil Failed 2. Damaged Wiring 3. Loose Connector Or Bent Pin 4. TCU Internal Failure.
- 6003Brake Light Relay Fault. 1. Short To 12 Volts 2. Open Circuit Or Short To Ground
- 6004CAN‐BUS Indicating Rear Diff Lock Switch Failed In The Armrest. Possible Failure Modes: 1. Rear Diff Lock Switch Failed In Armrest 2. Auto Diff Lock Switch Failed In Armrest (CCH Only) 3. Communication Problems Between The TCU Controller And The Armrest Controller.
- 6005Rear Differential Lock And Auto Differential Lock (Only CCH): 1. Diff Lock On And Auto Diff Lock Switches Are Both Active.
- 6006CAN‐BUS Indicating MFD (CCH) Or Front Diff Lock (4WD) Switch Failed In The Armrest. Possible Failure Modes: 1. MFD (CCH) Or Front Diff Lock (4WD) Failed In Armrest 2. Auto MFD Switch Failed In Armrest, (CCH). 3. Communication Problems Between The TCU Controller And The Armrest.
- 6007Both MFD And Auto MFD Switches Active Fault.
- 6008Steering Angle Sensor Above Maximum Voltage Limit.
- 6009Steering Angle Sensor Below Minimum Voltage Limit.
- 601012VS1 Voltage Supply Is Low. (Possible Blown Fuse*)
- 6011Permanent Four-Wheel Drive Switches And Sensors Supply Fuse Error
- 6014Short Circuit Between The Terminals Of The Four-Wheel Drive Solenoid Valve
- 6020Automatic Or Manual Four-Wheel Drive Selector Switch Faulty
- 6021Four-Wheel Drive Solenoid Stuck Off
- 6022Four Wheel Drive Solenoid Stuck Off
- 6023Four-Wheel Drive Clutch Solenoid Valve Open Circuit Or Short To Ground
- 6024FWD Solenoid Short Circuit To Battery
- 6025Frequency From The Front Shaft Speed Sensor (VAA) Too High
- 6031Voltage From The Front Shaft Speed Sensor (VAA) Too Low
- 6032Voltage From The Front Shaft Speed Sensor (VAA) Too High
- 6033Voltage From The Rear Shaft Speed Sensor (VAP) Too Low
- 6034Voltage From The Rear Shaft Speed Sensor (VAP) Too High
- 6035Frequency From The Front Shaft Speed Sensor (VAA) Too High
- 6036Frequency From The Rear Shaft Speed Sensor (VAP) Too High
- 6037Inconsistent Front And Rear Shaft Speed Sensor
- 6038Tilt Sensor Not Working, Shorted To Ground
- 6039Voltage From Tilt Sensor Too High
- 6041Steering Sensor Not Working Due To High Voltage
- 6042Steering Sensor Not Working Due To Low Voltage
- 613ADEF Supply Module Pump Motor Short Circuit to Battery Failure
- 6226Short Circuit in Injector 1
- 624EVehicle Speed CAN Message Not Received
- 627ADEF Dosing Valve Actuator Short Circuit to Battery in High Side Failure
- 6326Short Circuit Error of Injector in Cylinder 3
- 6371After Run Relay High Side Driver Circuit Short to Battery Failure
- 63B5Fuel Filter Heater Actuator is Shorted to Battery Voltage
- 6422Auxiliary Power Relay Low Side Driver Circuit Short to Battery Failure
- 6426Short Circuit Error of Injector in Cylinder 3
- 6455Fuel Metering Unit is Shorted to Battery Voltage at The High Side
- 6471After Run Relay High Side Driver Circuit Short to Ground Failure
- 647ADEF Dosing Valve Actuator Short Circuit to Battery Failure
- 647DSupply UB1 Short to Battery Failure
- 649ADEF Tank Heater Actuator Short Circuit to Battery Failure
- 6526Short Circuit Error of Injector in Cylinder 2
- 6626Short Circuit Error of Injector in Cylinder 2
- 6655Fuel Metering Unit is Shorted to Battery Voltage at The Low Side
- 667DSupply UB2 Short to Battery Failure
- 6722Starter Relay High Side Driver Circuit Short to Battery Failure
- 6726Short Circuit Error of Injector in Cylinder 4
- 6733Fan Clutch Solenoid Short Circuit to Battery Failure
- 6771After Run Relay Low Side Driver Circuit Short to Battery Failure
- 684EDEF Quality Sensor Internal Failure (Temperature Sensor Circuit Short to Battery)
- 687DSupply UB3 Short to Battery Failure
- 6A14Intake Air Heater Actuator is Shorted to Battery Voltage
- 6B22Starter Relay Low Side Driver Circuit Short to Battery Failure
- 6C5ADEF Reverting Valve Driver Circuit Short to Battery Failure
- 7Airflow Sensor Short To Battery Or Disconnected
- 7014Differential Lock Command Switch Error - Switch Disconnected
- 7017Differential Lock Solenoid Valve Open Circuit Or Short To Ground
- 7024Steering Angle Sensor Not Calibrated
- 7032Steering Angle Sensor - Signal Too Low
- 7100Autoguidance Isolation Solenoid Return - Disconnected / Over Temperature
- 7101Autoguidance Isolation Solenoid - Solenoid Return Short To Battery
- 7102Autoguidance Isolation Solenoid - Solenoid Return Short To Ground
- 7103Steering Angle Plausibility Error (Auto Guidance Only)
- 7104Timeout Of NAV2XCM CAN Message
- 7116Injection Bank 1 Short Circuit Failure (All Injectors of The Same Bank Can be Affected)
- 717ADEF Dosing Valve Actuator Short Circuit to Ground in High Side Failure
- 7216Injection Bank 2 Short Circuit Failure (All Injectors of The Same Bank Can be Affected)
Other Case machine types
Fault code lists by brand
- CAT8,286 codes
- Volvo6,508 codes
- New Holland Tractor3,475 codes
- FPT3,033 codes
- Bobcat2,653 codes
- Challenger Tractor2,434 codes
- New Holland Combine2,274 codes
- John Deere Tractors1,884 codes
- John Deere Engines1,853 codes
- Cummins1,847 codes
- Challenger Rubber Track Tractor1,747 codes
- Volvo Wheel Loader1,726 codes
- Deutz1,684 codes
- Perkins1,523 codes
Safety-critical: confirm before use
Safety first: park on level ground, stop the engine, and secure the machine before any inspection. Thresholds, component locations, wire numbers, fuse locations, and reset procedures can vary by model, configuration, and serial number. Confirm them in the service documentation for your exact machine.