HeavyEquipmentFix
Ask

Case IH Fault Codes List: P0697 to SPN 190 FMI 0

Page 28 of 30 of the full Case IH fault code list (2,992 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

Case IH codes P0697 to SPN 190 FMI 0

  • P0697ECU Internal 5v Supply 2 Auxiliary Fault
  • P0C18Failure During EGR Position Learning
  • P1219ECU - ECU Software Monitoring Fault
  • P1303No MDP Updates Occur Fault 2
  • P1311No MDP Updates Occur Fault 1
  • P1452DP Sensor Tube Inverted
  • P1453DP Sensor Tube Clamped
  • P1601ECU - Processor Data Fault
  • P1602ECU - Processor Code Fault
  • P1604ECU - Processor RAM Fault
  • P1606ECU - Supplementary Fault 1
  • P1607ECU - Supplementary Fault 2
  • P160BECU - QADC Multiplexor Fault
  • P160CECU - Engine Off Fault
  • P160DECU - Foot Pedal Fault
  • P160EECU - Hand Pedal Fault
  • P1611ECU - Injector Drive Disable Fail Fault
  • P1612ECU - Injector Drive Disable Fault
  • P1620ECU - L2 Trip Fault
  • P1621ECU - L3 Trip Fault
  • P1622ECU - ECU Reset Fail Fault
  • P1623ECU - Injection Locking Fault
  • P1624ECU - Nominal Mode Fault
  • P1625ECU - Background Flow Check Failure
  • P1626ECU - Background Cycle Check Failure
  • P1627ECU - Program Flow Check Failure
  • P1628ECU - Program Flow Cycle Check
  • P162BECU - Injector Drive Lock Fail Fault
  • P1630ECU - Pulse Check Bank Error
  • P1631ECU - Pulse Check Injector Code Correction Error
  • P1632ECU - Pulse Check Injector Number Error
  • P1633ECU - Pulse Check Fuel Quantity Error
  • P1634ECU - Pulse Check Injection Number Error
  • P1635ECU - Pulse Check TOFF Error
  • P1636ECU - Pulse Check TON Error
  • P1637ECU - Pulse Check Tooth Error
  • P1638ECU - Pulse Check Injection Type Error
  • P1660ECU - L1/L2 Pulses Comparison Fault 1
  • P1661ECU - L1/L2 Pulses Comparison Fault 2
  • P1662ECU - Injection Lock Fail After A Power Latch
  • P1663ECU - Reset Fail After A Power Latch
  • P1690ECU - QADC Slope High Fault
  • P1691ECU - QADC Slope Low Fault
  • P1692ECU - QST Timeout Fault
  • P16D2ECU - Reduced Torque Mode Fault
  • P16D6ECU - Engine Speed Fault
  • P16D8ECU - Pedal Monitoring Fault
  • P1978ECU - ESC Time Out Fault
  • P2080Exhaust Manifold Temp Sensor Plausibility Fault
  • P2081Exhaust Manifold Temp Sensor Noise Fault
  • P2120Hand Pedal Signal Track 1 Fault
  • P2125Hand Pedal Signal Track 2 Fault
  • P2135Foot Pedal Correlation Track 1 Over Track 2 Fault
  • P2138Hand Pedal Correlation Track 1 Over Track 2 Fault
  • P2228Atmospheric Pressure Sensor Low Fault
  • P2229Atmospheric Pressure Sensor High Fault
  • P224ADP Sensor Leak Detected
  • P2264Water in Fuel Sensor Fault
  • P2269Water in Fuel Detect
  • P2428Exhaust Over Temperature Fault
  • P242ADPF in Temp Sensor Fault
  • P242BDPF in Temp Sensor Plausibility Fault
  • P242CDPF in Temp Sensor Low Fault
  • P242DDPF in Temp Sensor High Fault
  • P242EDPF in Temp Sensor Noise Fault
  • P242FDPF Regeneration Error
  • P244ADP Sensor Leak Detected
  • P2453DP Sensor Plausibility Fault
  • P2454DP Sensor Low Fault
  • P2455DP Sensor High Fault
  • P2458DPF Overload Fault
  • P2463DPF Plugged Fault
  • P2687Fuel Heater Driver Fault
  • SPN 0 FMI 0Shutdown Mode: Allow to Run 30 Seconds Before Engine Shutdown: Data Valid but Above Normal Operational Range
  • SPN 100 FMI 1Engine Oil Pressure: Low, Most Severe
  • SPN 102 FMI 3Engine Intake Manifold #1 Pressure: Voltage Above Normal
  • SPN 102 FMI 4Engine Intake Manifold #1 Pressure: Voltage Below Normal
  • SPN 108 FMI 3Barometric Pressure: Voltage Above Normal
  • SPN 108 FMI 4Barometric Pressure: Voltage Below Normal
  • SPN 110 FMI 15Engine Coolant Temperature: High, Least Severe
  • SPN 110 FMI 3Engine Coolant Temperature: Voltage Above Normal
  • SPN 110 FMI 4Engine Coolant Temperature: Voltage Above Normal
  • SPN 1136 FMI 0Engine Control Unit (ECU) Temperature Malfunction: Data Valid But Above Normal Operational Range
  • SPN 14001Rear PTO Sensor Short to 12V
  • SPN 14002Rear PTO Speed Sensor Short to Ground
  • SPN 14021Cranking Line Shorted to 12V
  • SPN 14041Engine Coolant Temperature Sensor Open Circuit or Short to High Voltage
  • SPN 14042Engine Coolant Temperature Sensor Short to Ground
  • SPN 14051Fuel Level Sensor Open Circuit or Short to High Voltage
  • SPN 14052Fuel Level Sensor Short to Ground
  • SPN 14058Seat Switch Closed For Over 25 Hours
  • SPN 1485 FMI 7Engine Control Module (ECM) (Engine Control Unit (ECU)) Relay: Not Responding Properly
  • SPN 1485 FMI 8Engine Control Module (ECM) (Engine Control Unit (ECU)) Relay: Abnormal Frequency, Pulse Width or Period
  • SPN 14901Transmission Control Module Connection Error
  • SPN 168 FMI 0Battery Potential or Power Input 1: Data Valid But Above Normal Operational Range
  • SPN 168 FMI 3Battery Potential or Power Input 1: Voltage Above Normal
  • SPN 168 FMI 4Battery Potential or Power Input 1: Voltage Below Normal
  • SPN 172 FMI 3Engine Air Inlet Temperature: Voltage Above Normal
  • SPN 172 FMI 4Engine Air Inlet Temperature: Voltage Below Normal
  • SPN 190 FMI 0Engine Speed: Data Valid But Above Normal Operational Range
Looking for a different Case IH code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other Case machine types

Fault code lists by brand