HeavyEquipmentFix
Ask

CAT Fault Codes List: 3463 to 3556

Page 28 of 83 of the full CAT fault code list (8,286 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

CAT codes 3463 to 3556

  • 3463Remote Control Display Transceiver
  • 3464ETC not receiving command from ECM
  • 3465DPF #2 Intake Pressure Sensor
  • 3466Power Inverter Enable Feedback line
  • 3467Main Power Relay
  • 3473rd Function Lever not in hold position on startup
  • 3470Machine Power Distribution Relay
  • 3471Fuel Pressure 1 below desired (Low system pressure)
  • 3472ARD Air Pressure Control System
  • 3473Aftertreatment failed to ignite
  • 3474Aftertreatment loss of combustion
  • 3475Right Front Tire Pressure/Temperature Sensor
  • 3476Left Rear Inner Tire Pressure/Temperature Sensor
  • 3477Aftertreatment 2 failed to ignite
  • 3478Aftertreatment 2 loss of ignition
  • 3479AFT Fuel Doser Valve High Side Short circuit
  • 3484th Function Lever not in hold position on startup
  • 3480AFTFP1 sensor plausibility error
  • 3481Incorrect dosing pressure, multiple events
  • 3482AFT Fuel Shutoff Valve short to PWR
  • 3483Sensor Supply #4
  • 3484Throttle Selection Switch
  • 3485Aftertreatment #1 Exhaust Gas Temperature #1 Sensor
  • 3486Aftertreatment #1 Exhaust Gas Temperature #2 Sensor
  • 3487Aftertreatment #1 Exhaust Gas Temperature #3 Sensor
  • 3488Left Front Wheel Speed Sensor Signal Line #1
  • 3489Left Front Wheel Speed Sensor Signal Line #2
  • 349Lift linkage movement detected with no command given
  • 3490Right Front Wheel Speed Sensor Signal Line #1
  • 349-1Aftertreatment #1 Purge Air Pressure : Low - Least Severe (1)
  • 3492Engine Application
  • 3493Aftertreatment #1 Secondary Air Pressure Sensor
  • 3494Rear Hitch Float Switch
  • 3495Ejector Cylinder Head End Pressure Sensor
  • 3496Ejector Cylinder Rod End Pressure Sensor
  • 349-7Aftertreatment #1 Purge Air Pressure : Not Responding Properly
  • 3498Bowl Cylinder Position Sensor
  • 3499Apron Lower Anti Drift Solenoid
  • 350Tilt linkage movement detected with no command given
  • 3500Alternator Excitation Field Regulator Current Line
  • 3501Alternator Excitation Field Regulator
  • 3502Bowl Up Solenoid #1
  • 3503Bowl Up Solenoid #2
  • 3504Bowl Down Solenoid #1
  • 350-5Aftertreatment #1 Air Pressure Control : Current Below Normal
  • 350-6Aftertreatment #1 Air Pressure Control : Current Above Normal
  • 350-7Aftertreatment #1 Air Pressure Control : Not Responding Properly
  • 3508Engine Injector Metering Rail #1 Pressure Valve Solenoid
  • 3509VREF1 voltage deviation ECM pins: C1-36
  • 351Lift linkage movement detected in wrong direction
  • 3510VREF2 voltage deviation ECM pins: E1-85 and E1-86
  • 3511VREF3 voltage deviation ECM pins: E1-89
  • 3512VREF4 voltage deviation ECM pins: C1-37, C1-49, C2-08 and E1-58
  • 3513VREF5 voltage deviation ECM pins: C1-50, E1-81, and E1-82.
  • 3514VREF6 voltage deviation ECM pin: E1-88
  • 3515Engine Throttle Valve Position Sensor
  • 3516Blade Tip Solenoid
  • 3517Rear Hitch Enable Relay #1
  • 3518Aftertreatment DEF Conductivity Fault
  • 3519Aftertreatment DEF Temperature 2 Fault
  • 352Tilt linkage movement detected in wrong direction
  • 3520Aftertreatment DEF Properties Fault
  • 3521Traction Alternator #3 Rectifier
  • 3522Aftertreatment DEF Tank Level Fault
  • 3523PTO (Power Takeoff) #2 Attachment Pump Solenoid
  • 3524PTO (Power Takeoff) #1 Engagement Solenoid
  • 3525PTO (Power Takeoff) #2 Engagement Solenoid
  • 3526Direct Shift Gear Switch
  • 3527Direction Selector
  • 3528Barometric Pressure Sensor
  • 3529Hydraulic Oil Level/Temperature Sensor
  • 353Machine Configuration Changed
  • 3530Aftertreatment #1 Regeneration Disabled
  • 3531Aftertreatment #2 Regeneration Disabled
  • 3532Aftertreatment DEF Tank Level Fault
  • 3533Rear Differential Speed Sensor
  • 3534Left Front Axle Speed Sensor
  • 3535Right Front Axle Speed Sensor
  • 3536Left Center Axle Speed Sensor
  • 3537Right Center Axle Speed Sensor
  • 3538Left Rear Axle Speed Sensor
  • 3539Right Rear Axle Speed Sensor
  • 354Relative Humidity signal Out of Range HIGH
  • 3540Center Cross Axle Lock Solenoid
  • 3541Rear Cross Axle Lock Solenoid
  • 3542Interaxle Lock Accumulator Pressure Sensor
  • 3543Interaxle Lock Accumulator Charge Solenoid
  • 3544Interaxle Lock Solenoid
  • 3545Stick Cylinder Extend Pilot Pressure Sensor
  • 3546Stick Cylinder Retract Pilot Pressure Sensor
  • 3547Water in Fuel System Switch
  • 3549Engine Oil Filter Outlet Pressure Fault
  • 355High Left Turbine Speed
  • 3550Traction Alternator #2
  • 3551Traction Alternator #3
  • 3552Traction Alternator #1 Current Sensor
  • 3553Traction Alternator #2 Current Sensor
  • 3554Traction Alternator #3 Current Sensor
  • 3555Dust Bin blower Inverter
  • 3556AFT fuel injector not responding as expected
Looking for a different CAT code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other Caterpillar machine types

Fault code lists by brand