HeavyEquipmentFix
Ask

CAT Fault Codes List: 895 to 995

Page 39 of 83 of the full CAT fault code list (8,286 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

CAT codes 895 to 995

  • 895Headway controller left side sensor fault.
  • 896Headway controller rear sensor fault.
  • 897Override control mode priority fault.
  • 898Engine requested speed/speed limit fault.
  • 899Engine torque mode fault detected.
  • 90seconds, one of the following conditions must
  • 900Retarder torque mode fault detected.
  • 901Retarder type fault detected.
  • 902Retarder location fault detected.
  • 903Transmission forward direction switch fault.
  • 904Front axle speed fault detected.
  • 905Relative speed fault; front axle, left wheel.
  • 906Relative speed fault; front axle, right wheel.
  • 907Relative speed fault; rear axle #1, left wheel.
  • 908Relative speed fault; rear axle #1, right wheel.
  • 909Relative speed fault; rear axle #2, left wheel.
  • 91-08Invalid Throttle Signal
  • 911Unexpected Electric Retarding Grid #1 Current Detected
  • 91-13Accelerator Pedal Position 1 : Calibration Required
  • 915Left grade sensor arrow indicator lamps
  • 916Left grade sensor ON GRADE indicator lamp
  • 917Right grade sensor arrow indicator lamps
  • 91-8Accelerator Pedal Position 1 : Abnormal Frequency, Pulse Width, or Period
  • 919Ambient light sensor fault detected.
  • 920Audible alarm fault detected.
  • 921Green lamp fault detected.
  • 922Auto stop proximity switch
  • 923Service height proximity switch
  • 925Burner Control Diagnostic Lamp
  • 926Burner Selector Switch
  • 927Burner Fuel Pump Relay
  • 928Left Extender Glow Plug Relay
  • 929Left Extender Blower Motor
  • 930Left Extender Fuel Valve Solenoid
  • 931Engine Fuel Supply Pump Actuator fault
  • 932Brake Modulator Valve Solenoid Axle #1 Left fault
  • 933Brake Modulator Valve Solenoid Axle #1 Right fault
  • 934Brake Modulator Valve Solenoid Axle #2 Left fault
  • 935Brake Modulator Valve Solenoid Axle #2 Right fault
  • 936Brake Modulator Valve Solenoid Axle #3 Left fault
  • 937Brake Modulator Valve Solenoid Axle #3 Right fault
  • 938Brake Dump Modulator Valve Solenoid Axle #1 Left fault
  • 939Brake Dump Modulator Valve Solenoid Axle #1 Right fault
  • 940Brake Dump Modulator Valve Solenoid Axle #2 Left fault
  • 941Brake Dump Modulator Valve Solenoid Axle #2 Right fault
  • 942Brake Dump Modulator Valve Solenoid Axle #3 Left fault
  • 94-3Engine Fuel Delivery Pressure : Voltage Above Normal
  • 94-4Engine Fuel Delivery Pressure : Voltage Below Normal
  • 945Passenger Air Bag Ignitor Loop fault
  • 946Left Belt Tensioner Ignitor Loop fault
  • 947Right Belt Tensioner Ignitor Loop fault
  • 948Safety Restraint System Lamp fault
  • 949Seat Occupancy Sensor fault
  • 95Intake Valve Actuation System Oil Pressure voltage high
  • 950Side Collision Detector fault
  • 951Side Bag Ignitor Loop 1 fault
  • 955Side Bag Ignitor Loop 2 fault
  • 956Rollover Sensor fault
  • 957Rotor Lower Solenoid
  • 958Rotor Gear Switch
  • 959Rotor Speed Sensor
  • 960Rotor Clutch 1st Gear Solenoid
  • 96-03Fuel Level Voltage High
  • 96-04Fuel Level Voltage Low
  • 961Rotor Clutch 2nd Gear Solenoid
  • 962Rotor Clutch 3rd Gear Solenoid
  • 96-3Fuel Level : Voltage Above Normal
  • 96-4Fuel Level : Voltage Below Normal
  • 965Autodig Dig Mode Switch
  • 966TCS Dash Lamp
  • 967Machine Application
  • 968Transmission Hold Lamp
  • 969Front Cross Axle Lock Solenoid
  • 97Intake Valve Actuationr System Oil Pressure Solenoid current high
  • 970Center/Rear Cross Axle Lock Solenoid
  • 971Interaxle Differential Lock Solenoid
  • 972Left Station Left Auger Mode Switch
  • 973Left Station Left Conveyor Mode Switch
  • 974Remote APP signal Out of Range HIGH
  • 975Left Station Left Conveyor Speed Dial
  • 976Left Material Height Paddle Sensor
  • 977Left Material Height Sonic Sensor
  • 978Left Material Height Dial
  • 979Left Material Control Pump Solenoid
  • 98Engine Coolant Divertor current high
  • 980Left Conveyor Bypass Solenoid
  • 981Left Auger Reverse Solenoid
  • 982Left Auger Bypass Solenoid
  • 983Left Station Auger Rotation Switch
  • 984Material Control Diagnostic Lamp
  • 986Left Station Right Auger Mode Switch
  • 987Left Station Right Conveyor Mode Switch
  • 988Right Feeder Mode Switch
  • 989Left Station Right Conveyor Speed Dial
  • 99Engine Oil Filter Differential Pressure Sensor
  • 990Right Material Height Paddle Sensor
  • 991Right Material Height Sonic Sensor
  • 993Right Material Control Pump Solenoid
  • 994Right Conveyor Bypass Solenoid
  • 995Right Auger Reverse Solenoid
Looking for a different CAT code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other Caterpillar machine types

Fault code lists by brand