HeavyEquipmentFix
Ask

Deutz Fault Codes List: P1061 to P1263

Page 15 of 17 of the full Deutz fault code list (1,684 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

Deutz codes P1061 to P1263

  • P1061Engine rotation speed - data above normal range
  • P1062Engine rotation speed - data above normal range
  • P1065Oil level - fault reason exists
  • P1067DPF differential pressure issue detected
  • P1070Clutch signal abnormal change rate
  • P1071Engine shutdown requested due to irregular data
  • P1073EGR actuator position mechanical issue
  • P1075Ambient air temperature sensor irregular data
  • P1076Coolant temperature sensor irregular data
  • P1077DOC temperature after irregular data
  • P1078DOC temperature before irregular data
  • P1079DOC temperature before irregular data
  • P1080Separator voltage above normal
  • P1081Separator voltage below normal
  • P1082ECU identification irregular data
  • P1084Oil temperature sensor irregular data
  • P1089Inlet valve temperature physical limit exceeded
  • P1090Charge air pressure sensor irregular data
  • P1091Charge air pressure sensor below normal
  • P1092Throttle position voltage above normal
  • P1093Throttle position voltage below normal
  • P1095Throttle status irregular data
  • P1096Throttle signal error irregular data
  • P1097Torque reduction protection active
  • P1099Ambient air temperature sensor above normal
  • P1100ECU main relay voltage above normal or short to positive
  • P1101ECU main relay voltage above normal or short to positive
  • P1102ECU main relay voltage below normal or short to ground
  • P1103ECU main relay voltage below normal or short to ground
  • P1104ECU has a bad device or component
  • P1105ECU has a bad device or component
  • P1106ECU has a bad device or component
  • P1107ECU has a bad device or component
  • P1108ECU has a bad device or component
  • P1109ECU has a bad device or component
  • P1110ECU has a bad device or component
  • P1111ECU has a bad device or component
  • P1112ECU has a bad device or component
  • P1113ECU has a bad device or component
  • P1114ECU has a bad device or component
  • P1115ECU has a bad device or component
  • P1116ECU has a bad device or component
  • P1117ECU has a bad device or component
  • P1118ECU has a bad device or component
  • P1119ECU has a bad device or component
  • P1120ECU has a bad device or component
  • P1121ECU has a bad device or component
  • P1122ECU has a bad device or component
  • P1123ECU has a bad device or component
  • P1124ECU has a bad device or component
  • P1125ECU has a bad device or component
  • P1128Bad intelligent device or component
  • P1129Bad intelligent device or component
  • P1130Bad intelligent device or component
  • P1131Bad intelligent device or component
  • P1132Bad intelligent device or component
  • P1133Bad intelligent device or component
  • P1134Bad intelligent device or component
  • P1135Bad intelligent device or component
  • P1136Bad intelligent device or component
  • P1137Bad intelligent device or component
  • P1138Bad intelligent device or component
  • P1139Bad intelligent device or component
  • P1140ECU after-run too frequent, data irregular
  • P1141ECU main relay voltage above normal
  • P1142ECU main relay voltage below normal
  • P1143ECU main relay voltage above normal
  • P1144ECU main relay voltage below normal
  • P1145ECU main relay voltage above normal
  • P1146ECU main relay voltage below normal
  • P1147ECU main relay voltage above normal
  • P1148ECU main relay voltage below normal
  • P1149ECU main relay voltage above normal
  • P1168MCAN not enough memory, cause unknown
  • P1169MCANR not enough memory, cause unknown
  • P1173Replacement fault code triggered by FID
  • P1174Replacement fault code for low fuel pressure
  • P1175Replacement fault code triggered by FID
  • P1176Replacement fault code triggered by FID
  • P1177Replacement fault code triggered by FID
  • P1178Exhaust flap internal error, cause unknown
  • P1179Exhaust flap external error, cause unknown
  • P1200Replacement fault code triggered - fault exists
  • P1201Replacement fault code triggered - fault exists
  • P1202Replacement fault code triggered - fault exists
  • P1203Replacement fault code triggered - fault exists
  • P1204Replacement fault code triggered - fault exists
  • P1205Replacement fault code triggered - fault exists
  • P1206Dynamic dew point detection downstream sensor - fault exists
  • P1207Dynamic dew point detection upstream sensor - fault exists
  • P1251DPF sensor lines swapped - mechanical system unresponsive or blocked
  • P1253DPF pressure data irregular or incorrect
  • P1255Active stand still time data above normal range (severe)
  • P1256Stand still regeneration time data above normal range (moderate)
  • P1257Stand still regeneration time physical limit exceeded (high severity)
  • P1258Temperature downstream DOC data below normal range (severe)
  • P1260Temperature after DOC data irregular or incorrect
  • P1261Stand still time physical limit exceeded (high severity)
  • P1262NOx emissions after SCR Cat data irregular or incorrect
  • P1263DPF sensor incorrectly connected
Looking for a different Deutz code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other Deutz machine types

Fault code lists by brand