HeavyEquipmentFix
Ask

FPT Fault Codes List: 3F1C-1F to 41F3-1F

Page 19 of 31 of the full FPT fault code list (3,033 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

FPT codes 3F1C-1F to 41F3-1F

  • 3F1C-1FDPF Temp Monitoring
  • 3FADPF Regeneration - Maximum Number Exceeded
  • 3FDEDownstream NOx Sensor Signal and NH3 Sensor Signal Plausibility Check Failure
  • 3FDE-0NH3 Sensor
  • 4Short To Ground Or Pressure Sensor Disconnected
  • 4004ACM (GARU) Offline
  • 4005Levers Are Not Calibrated At Power Up
  • 41Indicator - Diagnostic Lamp (Electrical)
  • 4100Rear Remote No.1 – No Control Message Received
  • 4101Rear Remote No.1 ‐ Implausible EHR Control Messages
  • 4102Rear Remote No.1 ‐ Checksum Verification Failure
  • 4103Rear Remote No.1 – Switched To Failsafe
  • 4104Rear Remote No.1 – Under Voltage
  • 4105Rear Remote No.1 – Over Voltage
  • 4106Rear Remote No.1 ‐ Spool Deflection Too Short
  • 4107Rear Remote No.1 ‐ Spool Deflection Excessive
  • 4108Rear Remote No.1 ‐ Open Center Position Not Reached
  • 4109Rear Remote No.1 – Manually Operated
  • 4110Rear Remote No.1 ‐ Output Stage Faulty
  • 4111Rear Remote No.1 ‐ Position Transducer Faulty
  • 4112Rear Remote No.1 ‐ Spool Cannot be Brought Back To Neutral
  • 4112-0Engine Speed Sensing
  • 4112-1FEngine Speed Sensing
  • 4113Rear Remote No.1 ‐ Spool Not In Neutral When Switched On
  • 4114Rear Remote No.2 – No Control Message Received
  • 4115Rear Remote No.2 ‐ Implausible EHR Control Messages
  • 4116Rear Remote No.2 ‐ Checksum Verification Failure
  • 4117Rear Remote No.2 – Switched To Failsafe
  • 4118Rear Remote No.2 – Under Voltage
  • 4119Rear Remote No.2 – Over Voltage
  • 4120Rear Remote No.2 ‐ Spool Deflection Too Short
  • 4121Rear Remote No.2 ‐ Spool Deflection Excessive
  • 4122Rear Remote No.2 ‐ Open Center Position Not Reached
  • 4123Rear Remote No.2 – Manually Operated
  • 4124Rear Remote No.2 ‐ Output Stage Faulty
  • 4125Rear Remote No.2 ‐ Position Transducer Faulty
  • 4125-0Fuel Pressure (Rail) Sensor
  • 4125-1FFuel Pressure (Rail) Sensor
  • 4126Rear Remote No.2 ‐ Spool Cannot Be Brought Back To Neutral
  • 4127Rear Remote No.2 ‐ Spool Not In Neutral When Switched On
  • 4128Rear Remote No.3 – No Control Message Received
  • 4129Rear Remote No.3 ‐ Implausible EHR Control Messages
  • 4130Rear Remote No.3 ‐ Checksum Verification Failure
  • 4131Rear Remote No.3 – Switched To Failsafe
  • 4132Rear Remote No.3 – Under Voltage
  • 4133Rear Remote No.3 – Over Voltage
  • 4134Rear Remote No.3 ‐ Spool Deflection Too Short
  • 4135Rear Remote No.3 ‐ Spool Deflection Excessive
  • 4136Rear Remote No.3 ‐ Open Center Position Not Reached
  • 4137Rear Remote No.3 – Manually Operated
  • 4138Rear Remote No.3 ‐ Output Stage Faulty
  • 4139Rear Remote No.3 ‐ Position Transducer Faulty
  • 4140Rear Remote No.3 ‐ Spool Cannot Be Brought Back To Neutral
  • 4141Rear Remote No.3 ‐ Spool Not In Neutral When Switched On
  • 4142Rear Remote No.4 ‐ No EHR Control Messages
  • 4143Rear Remote No.4 ‐ Implausible EHR Control Messages
  • 4144Rear Remote No.4 ‐ Checksum Verification Failure
  • 4145Rear Remote No.4 ‐ Neutral Set Point
  • 4146Rear Remote No.4 ‐ Under Voltage
  • 4147Rear Remote No.4 ‐ Over Voltage
  • 4148Rear Remote No.4 ‐ Spool Deflection Too Short
  • 4149Rear Remote No.4 ‐ Spool Deflection Excessive
  • 4150Rear Remote No.4 ‐ Open Center Position Not Reached
  • 4151Rear Remote No.4 ‐ Manual Operation
  • 4152Rear Remote No.4 ‐ Output Stage Faulty
  • 4153Rear Remote No.4 ‐ Position Transducer Faulty
  • 4154Rear Remote No.4 ‐ Spool Cannot Be Brought Back To Neutral
  • 4155Fuel Metering Unit Intermittent Electrical Connection Failure
  • 4156Rear Remote No.5 ‐ No EHR Control Messages
  • 4157Rear Remote No.5 ‐ Implausible EHR Control Messages
  • 4158Rear Remote No.5 ‐ Checksum Verification Failure
  • 4159Rear Remote No.5 ‐ Neutral Set point
  • 4160Rear Remote No.5 ‐ Under Voltage
  • 4161Rear Remote No.5 – Over Voltage
  • 4162Rear Remote No.5 ‐ Spool Deflection Too Short
  • 4163Rear Remote No.5 ‐ Spool Deflection Excessive
  • 4164Rear Remote No.5 ‐ Open Center Position Not Reached
  • 4165Rear Remote No.5 ‐ Manual Operation
  • 4166Rear Remote No.5 ‐ Output Stage Faulty
  • 4167Rear Remote No.5 ‐ Position Transducer Faulty
  • 4168Rear Remote No.5 ‐ Spool Cannot Be Brought Back To Neutral
  • 4169Rear Remote No.5 ‐ Spool Not In Neutral When Switched On
  • 4170Rear Remote No.1 – Lever Not Calibrated
  • 4171EHR Control No.1 Open Circuit Or Short To GND
  • 4172EHR Control No.1 Short Circuit To Power Supply 5-12V
  • 4173Rear Remote No.2 ‐ Lever Not Calibrated
  • 4174EHR Control No.2 Open Circuit Or Short To GND
  • 4175EHR Control No.2 Short Circuit To Power Supply 5-12V
  • 4177Rear Remote No.3 ‐ Lever Not Calibrated
  • 4178EHR Control No.3 Open Circuit Or Short To GND
  • 4179EHR Control No.3 Short Circuit To Power Supply 5-12V
  • 4180Rear Remote No.4 ‐ Lever Not Calibrated
  • 4190Rear Remote No.1 – No Communications
  • 4191Rear Remote No.2 – No Communications
  • 4192Rear Remote No.3 – No Communications
  • 4193EHR 4 Offline Err
  • 4198EHR 5 Offline Err
  • 41D30.00min After Reagent Refill the Closed Loop Control Factor is Rise for 0.20 and a Leading Failure is Occurred - Bad Urea/Reagent/DEF Quality
  • 41ESCR Catalyst - Relation of Temperature Behavior Between Both Catalyst
  • 41F3-1FDecompression Brake
Looking for a different FPT code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Fault code lists by brand