HeavyEquipmentFix
Ask

Bobcat Fault Codes List: H9110 to M1144

Page 13 of 24 of the full Bobcat fault code list (2,653 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

Bobcat codes H9110 to M1144

  • H9110Fuel pressure at filter inlet too high.
  • H9111Fuel pressure at filter inlet extremely high.
  • H9121Fuel pressure out of range high.
  • H9122Fuel pressure out of range low.
  • H9144Fuel filter derate level 1.
  • H9145Fuel filter derate level 2.
  • H9202Fuel lift pump output error detected.
  • H9203Fuel lift pump output error resolved.
  • H9287Fuel lift pump protection time-out occurred.
  • H9309Fuel pressure is low.
  • H9314Fuel pressure is extremely low.
  • H9321Fuel pressure out of range high.
  • H9322Fuel pressure out of range low.
  • H9344Fuel pressure derate level 1 activated.
  • H9999Auxiliary controller has a bad table.
  • I0314LLMI undervoltage detected.
  • I0315LLMI overvoltage detected.
  • I3015LLMI sensor out of range.
  • I3017LLMI sensor ID error.
  • I3018LLMI sensor Rx out of delay.
  • I3113LLMI calibration values out of range.
  • I3121LLMI calibration values inverted.
  • I3122LLMI calibration values too close.
  • I3123LLMI calibration timeout.
  • I3901LLMI EEPROM failure.
  • I3903LLMI external watchdog default.
  • I3904LLMI wrong RAM test.
  • I3905LLMI wrong program checksum.
  • I3909LLMI test button error.
  • K1005Position lights output short to battery.
  • K1006Position lights output short to ground.
  • K1007Position lights output open circuit.
  • K1102Position lights status error ON.
  • K1103Position lights status error OFF.
  • K1205Low beam output short to battery.
  • K1206Low beam output short to ground.
  • K1207Low beam output open circuit.
  • K1305High beam output short to battery.
  • K1306High beam output short to ground.
  • K1307High beam output open circuit.
  • K1402Fog light output error ON.
  • K1403Fog light output error OFF.
  • K1505Left turn signal output short to battery.
  • K1506Left turn signal output short to ground.
  • K1507Left turn signal output open circuit
  • K1602Left turn signal status error ON
  • K1603Left turn signal status error OFF
  • K1705Right turn signal output short to battery
  • K1706Right turn signal output short to ground
  • K1707Right turn signal output open circuit
  • K1802Right turn signal status error ON
  • K1803Right turn signal status error OFF
  • K2002Front wiper output error ON
  • K2003Front wiper output error OFF
  • K2102Front wiper high speed output error ON
  • K2103Front wiper high speed output error OFF
  • K2202Front/roof washer output error ON
  • K2203Front/roof washer output error OFF
  • K2305Roof wiper output short to battery
  • K2306Roof wiper output short to ground
  • K2307Roof wiper output open circuit
  • K2405Rear wiper output short to battery
  • K2406Rear wiper output short to ground
  • K2407Rear wiper output open circuit
  • K2502Rear washer output error ON
  • K2503Rear washer output error OFF
  • K2605Lateral wiper output short to battery
  • K2606Lateral wiper output short to ground
  • K2607Rear wiper output open circuit
  • K2702Lateral washer output error ON
  • K2703Lateral washer output error OFF
  • K4204Left steering lever no communication
  • K4304Right steering lever no communication
  • K4404Steering lever no communication
  • L0102Lights Button Error On
  • L0202High-Flow Enable/Auto Idle Enable Button Error On
  • L0302Auxiliary Enable Button Error On
  • L0402Information Button Error On
  • L7672Left Display Panel Needs Programming
  • M0144Air Filter Derate Level 1
  • M0145Air Filter Derate Level 2
  • M0310System Voltage Too High
  • M0415Engine Oil Pressure in Shutdown
  • M0515Hydraulic Charge Pressure in Shutdown
  • M0610Engine Speed Too High
  • M0611Engine Speed Extremely High
  • M0615Engine Speed in Shutdown
  • M0618Engine Speed Out of Range
  • M0634Engine Speed Invalid Information from ECU
  • M0715Hydraulic Fluid Temperature in Shutdown
  • M0811Engine Coolant Temperature Extremely High
  • M0815Engine Coolant Temperature in Shutdown
  • M0826Engine Coolant Temperature Pre-Shutdown
  • M1009Fuel filter pressure low
  • M1014Fuel filter pressure extremely low
  • M1021Fuel filter pressure out of range high
  • M1022Fuel filter pressure out of range low
  • M1117Fuel filter is plugged
  • M1119Fuel filter is extremely plugged
  • M1144Fuel filter de-rate level 1
Looking for a different Bobcat code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Fault code lists by brand