HeavyEquipmentFix
Ask

New Holland Tractor Fault Codes List: 3C8 to 4175

Page 24 of 35 of the full New Holland Tractor fault code list (3,475 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

New Holland Tractor codes 3C8 to 4175

  • 3C8CAN Communication Failure Between Vehicle Controller and ECU Controller - TSC1_VE Message
  • 3CAEDownstream NOx Sensor Lambda Signal Deviation - NOx Sensor Possible Removal Detected
  • 3CDAUpstream NOx Sensor Comparison to a Calculated NOx Value Failure
  • 3D1CDOC Upstream Temperature Sensor Signal Drift at Cold Start
  • 3D4ECU Internal Failure - Loss of Synchronization to MM from CPU
  • 3DB4Open Load Error For Powerstage
  • 3DBADEF Pressure Line Heater Failure and DEF Tank Temperature is Too Low
  • 3DD6DEF Tank Level Sensor - System Error
  • 3E1CSCR Upstream Temperature Sensor Signal Drift at Cold Start
  • 3E27EGR OBD Monitoring Error
  • 3E3ECU Internal Failure - Fuel Injection Energizing Phase is Not Plausible
  • 3E3ADEF Supply Module Temperature Sensor Cold Start Plausibility Failure
  • 3E6APlausibility of the Absolute Difference Between the Battery Voltage and Power Stage Voltage of Backflow and Suction Line Heater
  • 3E9APlausibility of the Absolute Difference Between the Battery Voltage and Power Stage Voltage of Supply Module Heater
  • 3F1CSCR Downstream Temperature Sensor Signal Drift at Cold Start
  • 3F6DOC Inlet Temperature Sensor Voltage is Higher Than Expected
  • 3F6APlausibility of the Absolute Difference of Battery Voltage and the Powerstage of the Pressure Line
  • 3F9AError in Dosing Valve Plausibility at Low Voltage
  • 3FDEDownstream NOx Sensor Signal and NH3 Sensor Signal Plausibility Check Failure
  • 4Hitch Raise Solenoid Failed Open or Shorted to Ground
  • 4004ACM (GARU) Offline
  • 4005Levers Are Not Calibrated at Power Up
  • 4014Engine Coolant Temperature Sensor Error
  • 41the ARU Specified Tractor without Draft Control, but Detected Draft Pins
  • 4100Rear Remote No. 1 - No Control Message Received
  • 4101Rear Remote No. 1 - Control Message Not Plausible
  • 4102Rear Remote No. 1 - EEPROM Error
  • 4103Rear Remote No. 1 - Not Commanded Neutral on Power-Up
  • 4104Rear Remote No. 1 - Under Voltage
  • 4105Rear Remote No. 1 - Over Voltage
  • 4106Rear Remote No. 1 - Spool Movement Too Low
  • 4107Rear Remote No. 1 - Spool Movement Too High
  • 4108Rear Remote No. 1 - Float Position Not Reached
  • 4109Rear Remote No. 1 - Manually Operated
  • 4110Rear Remote No. 1 - Driver Faulty
  • 4111Rear Remote No. 1 - Internal Position Sensor Faulty
  • 4112Camshaft Speed Sensor Pattern is Not Plausible
  • 4113Rear Remote No. 1 - Spool Not in Neutral at Key On
  • 4114Rear Remote No. 2 - No Control Message Received
  • 4115Rear Remote No. 2 - Control Message Not Plausible
  • 4116Rear Remote No. 2 - EEPROM Error
  • 4117Rear Remote No. 2 - Not Commanded Neutral on Power-Up
  • 4118Rear Remote No. 2 - Under Voltage
  • 4119Rear Remote No. 2 - Over Voltage
  • 4120Rear Remote No. 2 - Spool Movement Too Low
  • 4121Rear Remote No. 2 - Spool Movement Too High
  • 4122Rear Remote No. 2 - Float Position Not Reached
  • 4123Rear Remote No. 2 - Manually Operated
  • 4124Rear Remote No. 2 - Driver Faulty
  • 4125Rear Remote No. 2 - Internal Position Sensor Faulty
  • 4126Rear Remote No. 2 - Unable to Reach Neutral
  • 4127Rear Remote No. 2 - Spool Not in Neutral at Key On
  • 4128Rear Remote No. 3 - No Control Message Received
  • 4129Rear Remote No. 3 - Control Message Not Plausible
  • 4130Rear Remote No. 3 - EEPROM Error
  • 4131Rear Remote No. 3 - Not Commanded Neutral on Power-Up
  • 4132Rear Remote No. 3 - Under Voltage
  • 4133Rear Remote No. 3 - Over Voltage
  • 4134Rear Remote No. 3 - Spool Movement Too Low
  • 4135Rear Remote No. 3 - Spool Movement Too High
  • 4136Rear Remote No. 3 - Float Position Not Reached
  • 4137Rear Remote No. 3 - Manually Operated
  • 4138Rear Remote No. 3 - Driver Faulty
  • 4139Rear Remote No. 3 - Internal Position Sensor Faulty
  • 4140Rear Remote No. 3 - Unable to Reach Neutral
  • 4141Rear Remote No. 3 - Spool Not in Neutral at Key On
  • 4142[A] Rear Remote No.4 No Control Message Received [B] Rear Remote No.3 No Control Message Received
  • 4143Rear Remote No. 4 - Control Message Not Plausible
  • 4144Rear Remote No. 4 - EEPROM Error
  • 4145Rear Remote No. 4 - Not Commanded Neutral on Power-Up
  • 4146Rear Remote No. 4 - Under Voltage
  • 4147Rear Remote No. 4 - Over Voltage
  • 4148Rear Remote No. 4 - Spool Movement Too Low
  • 4149Rear Remote No. 4 - Spool Movement Too High
  • 4150Rear Remote No. 4 - Float Position Not Reached
  • 4151Rear Remote No. 4 - Manually Operated
  • 4152Rear Remote No. 4 - Driver Faulty
  • 4153Rear Remote No. 4 - Internal Position Sensor Faulty
  • 4154Rear Remote No. 4 - Unable to Reach Neutral
  • 4155Fuel Metering Unit Intermittent Electrical Connection Failure
  • 4156Rear Remote No. 5 - No Control Message Received
  • 4157Rear Remote No. 5 - Control Message Not Plausible
  • 4158Rear Remote No. 5 - EEPROM Error
  • 4159Rear Remote No. 5 - Not Commanded Neutral on Power-Up
  • 4160Rear Remote No. 5 - Under Voltage
  • 4161Rear Remote No. 5 - Over Voltage
  • 4162Rear Remote No. 5 - Spool Movement Too Low
  • 4163Rear Remote No. 5 - Spool Movement Too High
  • 4164Rear Remote No. 5 - Float Position Not Reached
  • 4165Rear Remote No. 5 - Manually Operated
  • 4166Rear Remote No. 5 - Driver Faulty
  • 4167Rear Remote No. 5 - Internal Position Sensor Faulty
  • 4168Rear Remote No. 5 - Unable to Reach Neutral
  • 4169Rear Remote No. 5 - Spool Not in Neutral at Key On
  • 4170Rear EHR Control No.1 Not Calibrated [A] & [B]
  • 4171EHR Control No.1 Open Circuit or Short to GND
  • 4172EHR Control No.1 Short Circuit to Power Supply 5 - 12V
  • 4173Rear EHR Control No.2 Not Calibrated [A] & [B]
  • 4174EHR Control No.2 Open Circuit or Short to GND
  • 4175EHR Control No.2 Short Circuit to Power Supply 5 - 12V
Looking for a different New Holland Tractor code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other New Holland machine types

Fault code lists by brand