HeavyEquipmentFix
Ask

New Holland Fault Codes List: 3790 to 4141

Page 11 of 15 of the full New Holland fault code list (1,492 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

New Holland codes 3790 to 4141

  • 3790Diesel Particulate Filter (DPF) -Flow Resistance Exceeded Maximum Limit
  • 3791Diesel Particulate Filter (DPF) - Flow Resistance Too High
  • 3794Intake Air Pressure and Temperature Sensor - Signal Not Plausible
  • 3795Intake Air Pressure and Temperature Sensor - Signal Not Plausible
  • 3796Diesel Particulate FiIter Sensor Hose Line Error
  • 3797Differential Pressure Sensor - Signal Too High
  • 3798Differential Pressure Sensor - Signal Too Low
  • 3799Pressure Relief Valve: Pressure Relief Valve is Forced to Open Perform Pressure Shock
  • 3800Pressure Relief Valve: Quantity Balance Check if a Successful PRV Opening is Ensured
  • 3801Exhaust Manifold Pressure Sensor - Signal Too High
  • 3802Exhaust Manifold Pressure Sensor - Signal Too Low
  • 3803ECU Internal: Error on R2S2 Module (Low Level Chip Driver for the Power Stage Chips)
  • 3808Fuel Metering Unit: Set Point of Metering Unit Not Plausible
  • 3810Common Rail Pressure Sensor - Intermittent Signal
  • 3811ECU Sensor Supply Monitor: ECU Internal: Error Sensor Supplies 1
  • 3812Physical Range Check High for ECU Temperature Sensor
  • 3813Physical Range Check Low for ECU Temperature Sensor
  • 3814ECU Temperature Sensor: SPI Error ECU Temperature Sensor (LM71)
  • 3818Throttle Valve Actuator (TVA) - Open Circuit
  • 3819Throttle Valve Actuator (TVA) - Over-Current at Power Stage
  • 3820Throttle Valve Actuator (TVA) - Over-Temperature at Power Stage
  • 3821Throttle Valve Actuator (TVA) - Short Circuit to Battery at Out1 of Power Stage
  • 3822Throttle Valve Actuator (TVA) - Short Circuit to Battery at Out2 of Power Stage
  • 3823Throttle Valve Actuator (TVA) - Short Circuit to Ground at Out1 of Power Stage
  • 3824Throttle Valve Actuator (TVA) - Short Circuit to Ground at Out2 of Power Stage
  • 3825Throttle Valve Actuator (TVA) - Short Circuit at Power Stage
  • 3826Throttle Valve Actuator (TVA) - Temperature Dependent Over-Current at Power Stage
  • 3827Throttle Valve Actuator (TVA) - Under-Voltage at Power Stage
  • 3830Throttle Valve Actuator (TVA) - Position Signal Too High
  • 3831Throttle Valve Actuator (TVA) - Position Signal Too Low
  • 3834Throttle Valve Actuator (TVA) - Position Signal Too High
  • 3835Throttle Valve Actuator (TVA) - Position Signal Too Low
  • 3838Diesel Oxidation Catalyst (DOC) Inlet Temperature Sensor Signal Too High
  • 3839Diesel Oxidation Catalyst (DOC) Inlet Temperature Sensor Signal Too Low
  • 3840Diesel Particulate Filter (DPF) Inlet Temperature Sensor Signal Too High
  • 3841Diesel Particulate Filter (DPF) Inlet Temperature Sensor Signal Too Low
  • 3842Exhaust Manifold Temperature Sensor - Signal Too High
  • 3843Exhaust Manifold Temperature Sensor - Signal Too Low
  • 3844Error State On Comparing Energizing Time to Maximum Value Injector 1
  • 3845Error State On Comparing Energizing Time to Maximum Value Injector 2
  • 3846Error State On Comparing Energizing Time to Maximum Value Injector 3
  • 3847Error State On Comparing Energizing Time to Maximum Value Injector 4
  • 3848Error State On Comparing Energizing Time to Minimum Value Injector 1
  • 3849Error State On Comparing Energizing Time to Minimum Value Injector 2
  • 3850Error State On Comparing Energizing Time to Minimum Value Injector 3
  • 3851Error State On Comparing Energizing Time to Minimum Value Injector 4
  • 3852Lambda Sensor - Insufficient Heater Performance
  • 3870CAN-Bus Message Timeout - BC2EDC1 From ADIC
  • 3899Info: Engine Temperature Exceeded Pre-Warn Level
  • 3900Info: Engine Temperature Exceeded Warn Level
  • 3906Injector: Number of Injections is Limited by Quantity Balance of High Pressure Pump
  • 3910High Pressure Pump Solenoid Valve - Intermittent Connection to ECU
  • 3915Pressure Relief Valve: Averaged Rail Pressure is Outside the Expected Range with Open PRV
  • 3916Pressure Relief Valve: Open Time of PRV for Wear Out Monitoring had Exceeded Maximum Value
  • 3999Unknown ECM Error Code Received
  • 4Short to Ground or Pressure Sensor Disconnected
  • 4004ACM (GARU) Offline
  • 4005Levers Are Not Calibrated At Power Up
  • 4100Rear Remote No.1 No Control Message Received
  • 4101Rear Remote No.1 ‐ Implausible EHR Control Messages
  • 4102Rear Remote No.1 ‐ Checksum Verification Failure
  • 4103Rear Remote No.1 Switched to Failsafe
  • 4104Rear Remote No.1 ‐ Under Voltage
  • 4105Rear Remote No.1 ‐ Over Voltage
  • 4106Rear Remote No.1 ‐ Spool Deflection Too Short
  • 4107Rear Remote No.1 ‐ Spool Deflection Excessive
  • 4108Rear Remote No.1 ‐ Open Center Position Not Reached
  • 4109Rear Remote No.1 - Manually Operated
  • 4110Rear Remote No.1 ‐ Output Stage Faulty
  • 4111Rear Remote No.1 ‐ Position Transducer Faulty
  • 4112Rear Remote No.1 ‐ Spool Cannot be Brought Back To Neutral
  • 4113Rear Remote No.1 ‐ Spool Not In Neutral When Switched On
  • 4114Rear Remote No.2 No Control Message Received
  • 4115Rear Remote No.2 ‐ Implausible EHR Control Messages
  • 4116Rear Remote No.2 ‐ Checksum Verification Failure
  • 4117Rear Remote No.2 - Switched to Failsafe
  • 4118Rear Remote No.2 - Under Voltage
  • 4119Rear Remote No.2 ‐ Over Voltage
  • 4120Rear Remote No.2 ‐ Spool Deflection Too Short
  • 4121Rear Remote No.2 ‐ Spool Deflection Excessive
  • 4122Rear Remote No.2 ‐ Open Center Position Not Reached
  • 4123Rear Remote No.2 - Manually Operated
  • 4124Rear Remote No.2 ‐ Output Stage Faulty
  • 4125Rear Remote No.2 ‐ Position Transducer Faulty
  • 4126Rear Remote No.2 ‐ Spool Cannot Be Brought Back To Neutral
  • 4127Rear Remote No.2 ‐ Spool Not In Neutral When Switched On
  • 4128Rear Remote No.3 No Control Message Received
  • 4129Rear Remote No.3 ‐ Implausible EHR Control Messages
  • 4130Rear Remote No.3 ‐ Checksum Verification Failure
  • 4131Rear Remote No.3 - Switched to Failsafe
  • 4132Rear Remote No.3 - Under Voltage
  • 4133Rear Remote No.3 - Over Voltage
  • 4134Rear Remote No.3 ‐ Spool Deflection Too Short
  • 4135Rear Remote No.3 ‐ Spool Deflection Excessive
  • 4136Rear Remote No.3 ‐ Open Center Position Not Reached
  • 4137Rear Remote No.3 - Manually Operated
  • 4138Rear Remote No.3 ‐ Output Stage Faulty
  • 4139Rear Remote No.3 ‐ Position Transducer Faulty
  • 4140Rear Remote No.3 ‐ Spool Cannot Be Brought Back To Neutral
  • 4141Rear Remote No.3 ‐ Spool Not In Neutral When Switched On
Looking for a different New Holland code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other New Holland machine types

Fault code lists by brand