HeavyEquipmentFix
Ask

New Holland Fault Codes List: 3330 to 3550

Page 9 of 15 of the full New Holland fault code list (1,492 codes). Each entry is the code as the machine reports it and what the manufacturer data says it means.

New Holland codes 3330 to 3550

  • 3330Timeout Of CAN Message TSC1‐DE (When Inactive)
  • 3331Timeout Of CAN Message TSC1‐DE (When Active)
  • 3332Timeout Of CAN Message TSC1‐DR (When Inactive)
  • 3333Timeout Of CAN Message TSC1‐DR (When Active)
  • 3334Timeout of CAN Message TSC1-PE Torque (When Active)
  • 3335Timeout of CAN Message TSC1-PE Torque (When Inactive)
  • 3336Timeout Of CAN Message TSC1‐TR (When Inactive)
  • 3337Timeout Of CAN Message TSC1‐TR (When Active)
  • 3338Timeout of CAN Message TSC1-VE Speed (When Inactive)
  • 3339Timeout of CAN Message TSC1-VE Speed (When Active)
  • 3340Timeout Of CAN Message Time Date
  • 3341Timeout Of CAN Message HRVD (High Resolution Vehicle Distance)
  • 3342Power Stage Air Heater 2 Actuator ‐ No Signal
  • 3343Power Stage Air Heater 2 Actuator ‐ Signal High
  • 3344Power Stage Air Heater 2 Actuator ‐ Signal Low
  • 3345Total Throttle Failure (Only Applies To Dual Throttle Vehicles)
  • 3346Multiple State Switch
  • 3347Multiple State Switch
  • 3348Multiple State Switch
  • 3349Multiple State Switch
  • 3350Terminal 50 - Always On
  • 3351Engine Brake Decompression Valve ‐ Open Load
  • 3352Engine Brake Decompression Valve – Short Circuit To Battery
  • 3353Engine Brake Decompression Valve – Short Circuit To Ground
  • 3354Main Relay 4 (Engine Brake Exhaust Valve) – Short Circuit To Ground
  • 3355Main Relay 4 (Engine Brake Exhaust Valve) ‐ Short To Battery Or Open Load
  • 3356Cylinder Shutoff (Cylinder Balancing Disabled) ‐ Shutoff Active
  • 3357Misfire In Multiple Cylinders ‐Too Many Misfires
  • 3358CAN Transmit Timeout
  • 3359TSC Demand Physically Implausible
  • 3360Driving Dynamic Control ‐ Not Plausible
  • 3361ECM EEPROM - General Error
  • 3362Torque to Quantity Map - Not Plausible
  • 3363Atmospheric Pressure Sensor ‐ Processed via ADC (No CAN Plausibility Performed)
  • 3364Foot Pedal 2 ‐ Signal Too High
  • 3365Foot Pedal 2 ‐ Signal Too Low
  • 3366Foot Pedal 2 ‐ Signal Not Plausible Compared to Foot Pedal 1
  • 3367Coolant Temperature Test Failure
  • 3368Info: Torque Limitation Due to OBD Performance Limiter by Legislation
  • 3369Torque Reduction Due To Smoke Limitation
  • 3370Info: Torque Limitation Due To Engine Protection (Against Excessive Torque, Engine Over Speed And Overheat)
  • 3371Info: Torque Limitation Due To Fuel Quantity Limitation Because Of Injection System Errors
  • 3372Injection Quantity Adjustment Failure ‐ Invalid Adjustment Value
  • 3373Injection Quantity Adjustment Failure ‐ EEPROM Adjustment Value Not Readable
  • 3374Injection Quantity Adjustment Failure - Invalid EEPROM Adjustment Value Checksum
  • 3375Constant Engine RPM Increase / Decrease Switch – Short Circuit To Battery
  • 3376Engine Controller Software Does Not Support Power Management (Engine Power Management Option Enabled, But Engine Software Not Compatible)
  • 3377Constant Engine RPM Switch Detected But Option Not Enabled.
  • 3380Engine Fan Increase Speed Error (Open Or Short Circuit)
  • 3381Engine Fan Decrease Speed Error (Open Or Short Circuit)
  • 3382Fan Control Solenoid Short To 12 Vr
  • 3383Fan Control Solenoid Open Or Short To GND
  • 3384Vistronic Engine Cooling Fan Driver Open Or Short Circuit
  • 3399Engine Fuel Lift Pump Relay Driver Over Current Fault
  • 3402Rail Pressure Sensor: Maximum Rail Pressure Exceeded
  • 3403Starter Relay LS Power Stage Over Temperature
  • 3405ECU Power Stages: Open Load Temperature Error on the Turbocharger PWM Output Power Stage
  • 3406ECU Power Stages: Over Temperature Error on the Turbocharger PWM Output Power Stage
  • 3408Lambda Sensor: Oxygen Concentration Implausibly High
  • 3409Engine Oil Pressure Switch - Oil Pressure Too Low
  • 3410Permanent Governor Deviation for Valve
  • 3411Permanent Governor Deviation for Valve
  • 3414Short Circuit in Glow Plug 1
  • 3415Short Circuit Glow Plug - Cyl 2
  • 3416Short Circuit Glow Plug - Cyl 3
  • 3417Short Circuit Glow Plug - Cyl 4
  • 3418ECU Power Stages: Short Circuit to Battery Error on the Turbocharger PWM Output Power Stage
  • 3419ECU Power Stages: Short Circuit to Ground Error on the Turbocharger PWM Output Power Stage
  • 3420CAN Bus Received Frames: DFC of Auxiliary Engine Shutdown Switch Message
  • 3421Fuel FiIter Restriction Sensor - Signal Too High
  • 3422Fuel FiIter Restriction Sensor - Signal Too Low
  • 3423Fuel FiIter Restriction Sensor - Implausible Signal
  • 3424Fuel FiIter Restriction Sensor - Filter Clogged
  • 3425Turbocharger: Over Boost Deviation at P2 Too High in Pressure Charger Regulator
  • 3426Diesel Particulate Filter (DPF) - Level 1 Reached
  • 3427Diesel Particulate FiIter (DPF): Signal Range Check How Resistance of the Particulate Filter Low
  • 3428Diesel Particulate FiIter Pressure Sensor: Not Plausibility Error
  • 3429Diesel Particulate FiIter Pressure Sensor: Hoseline Plausibility Error
  • 3430EGR Inducement Less Severe Derating Level
  • 3431EGR Inducement Most Severe Derating Level
  • 3432Exhaust Gas Recirculation (EGR) - Inducement Warning
  • 3433Diesel Particulate FiIter (DPF) Inducement Less Severe Derating Level
  • 3434Diesel Particulate FiIter (DPF) Inducement Most Severe Derating Level
  • 3435Diesel Particulate Filter (DPF) - Inducement Warning
  • 3513SCR Catalyst Not Present – Relation Of Temperature Behavior Between Both Catalyst Temperatures Not Plausible
  • 3517Ambient Air Temperature Sensor Failure (Of Humidity Sensor) ‐ Signal Too high
  • 3518Ambient Air Temperature Sensor Failure (Of Humidity Sensor) ‐ Signal Too Low
  • 3519Ambient Air Temperature Sensor Failure (Of Humidity Sensor) ‐ CAN Signal Failure
  • 3521NOx Estimation Failure ‐Estimated Nox Signal Not Reliable
  • 3528NOx Sensor Plausibility Failure ‐ Signal Not Plausible
  • 3529NOx Sensor Failure ‐ Open Load
  • 3530NOx Sensor Failure ‐ Short Circuit
  • 3532NOx Sensor Failure ‐ Sensor Not Ready In Time
  • 3533CAN Message Timeout Nox (From Nox Sensor) ‐ CAN Timeout
  • 3537CAN Message Timeout DM1DCU (From DCU) ‐ CAN Timeout
  • 3541CAN Message Timeout SCR1 (From DCU) ‐ CAN Timeout
  • 3545Info: SCR Dosing Valve Overheat Protection ‐ Torque Limitation Level 2 For SCR Protection Active
  • 3546Info: SCR Dosing Valve Overheat Protection ‐ Torque Limitation Level 1 For SCR Protection Active
  • 3549Humidity Sensor Signal Ratio Failure ‐ Signal Ratio Above Limit
  • 3550Humidity Sensor Signal Ratio Failure ‐ Signal Ratio Below Limit
Looking for a different New Holland code?Search the full fault-code database, or hand the code to the AI assistant for a plain-English explanation.

Other New Holland machine types

Fault code lists by brand